C_TFIN52_66日本語勉強の資料、VCP5-DCV日本語認定資格、C_TSCM62_65日本語問題集

http://www.japancert.com/C_TFIN52_66-JP.html

NS0-506予想試験、NS0-506模擬練習

NO.1 A customer has a host experiencing performance problems with its FC LUNs. The customer has
examined the nodes hosting the LUNs, and both the disk and CPU performance are below 50%
utilization. The customer examined the switch ports connected to the storage array, and they are also
below 50% utilization.
Which three should the customer verify? (Choose three.)
A. that the HBA queue depth is set properly
B. that the host HBA has the correct port settings
C. that the host Ethernet interfaces are using jumbo frames
D. that the host is running SnapDrive
E. that the FC switch ports connected to the host have not exceeded the maximum capacity
Answer: C,D

Network Appliance受験記   NS0-506   NS0-506攻略   NS0-506模擬練習   NS0-506日本語サンプル   NS0-506通信

NO.2 Map the LUN to the igroup.

NO.3 A company has 50 ESXi hosts connected using FC to a single target port on a NetApp cluster.
Ten hosts are configured with an HBA queue depth on 128. Forty hosts are configured with a HBA
queue depth of 32.
They are experiencing performance problems with their FC LUNs.
Which two actions will resolve the problem? (Choose two.)
A. Use VSC to set recommended values for the hosts.
B. Reduce the HBA queue depth on the on the applicable HBAs.
C. Add additional target ports to allow for greater initiator distribution.
D. Increase the total queue depth on the NetApp cluster.
Answer: A

Network Applianceオフィシャル   NS0-506   NS0-506認証試験

NO.4 Which protocol allows to access a controller's CLI interface?
A. SSH
B. NTP
C. TFTP
D. IMAP
Answer: A

Network Appliance   NS0-506合格   NS0-506   NS0-506対策   NS0-506問題集
Reference:https://library.netapp.com/ecm/ecm_download_file/ECMP1196798(page 11)

NO.5 You have executed the following FC configuration workflow:
1.Verify IMT supported configuration.
2.Install VSC for VMware vSphere on a Windows Server.
3.Add the storage cluster to VSC and set recommended values.
4.Update host HBA firmware and BIOS.
5.Provision the LUN.
6.Manually create an igroup and add the host WWPNs into it.

NO.6 A Windows 2012 Server has a 1 GB thin-provisioned LUN in a 10 GB thin-provisioned volume.
After copying a 500 MB file to the LUN, you observe the LUN using 500 MB of space in the volume.
After deleting the 500 MB file, you observe the LUN is still using 500 MB of space in the volume.
Which two steps are required to reclaim the space? (Choose two.)
A. Press Optimize in the Windows Defragment and Optimize Drives utility.
B. Enablespace-allocationon the LUN.
C. Run TRIM on the host.
D. Empty the Recycle Bin on the host.
Answer: C

Network Appliance復習問題集   NS0-506   NS0-506   NS0-506開発入門

NO.7 Create datastore and its containing LUNS and volumes.
In step 8, you are not able to see the LUNs you provisioned on your storage controller. When you run
igroup show you see the ESX host's initiators; however, they are listed "not logged in". What is the
problem?
A. You need to configure ALUA.
B. TheLUN was not put online.
C. The LUN type is not set to type VMware.
D. You need to configure zoning.
Answer: D

Network Applianceワークスペース   NS0-506学校   NS0-506   NS0-506受験

NO.8 Click the Exhibit button.
A customer has deployed a new FAS8080EX running clustered Data ONTAP 8.3. Host A is running
multipath software that has been properly configured. Also, Host A is currently accessing a LUN using
the FC protocol stored on Node A.
Switch A, shown in the exhibit, fails.
What will happen next?
A. Node A will panic causing a storage failover to Node B.
B. Host A will lose all access to its LUN.
C. Host A will continue to access its LUN using Switch B through Node B.
D. Host A will continue to access its LUN using Switch B through Node A.
Answer: B

Network Applianceおすすめ   NS0-506模擬試験   NS0-506返金   NS0-506

JapanCertのNetwork ApplianceのNS0-506の試験問題と解答は実践されて、当面の市場で最も徹底的な正確的な最新的な模擬テストです。JapanCertは広い研究と実際を基づいている経験及び正確的な学習教材を提供できます。私たちは君の最も早い時間でNetwork ApplianceのNS0-506試験に合格するように頑張ります。もし私たちのNetwork ApplianceのNS0-506問題集を購入したら、JapanCertは一年間無料で更新サービスを提供することができます。

チャンスは常に準備ができあがった者に属します。しかし、我々に属する成功の機会が来たとき、それをつかむことができましたか。Network ApplianceのNS0-506認定試験を受験するために準備をしているあなたは、JapanCertという成功できるチャンスを掴みましたか。JapanCertのNS0-506問題集はあなたが楽に試験に合格する保障です。この問題集は大量な時間を節約させ、効率的に試験に準備させることができます。JapanCertの練習資料を利用すれば、あなたはこの資料の特別と素晴らしさをはっきり感じることができます。この問題集は間違いなくあなたの成功への近道で、あなたが十分にNS0-506試験を準備させます。

試験番号:NS0-506 トレーニング
試験科目:「NetApp Certified Implementation Engineer - SAN, Clustered Data ONTAP」
最近更新時間:2015-11-11
問題と解答:65

>> NS0-506 トレーニング

 

あなたの予算が限られている場合に完全な問題集を必要としたら、JapanCertのNetwork ApplianceのNS0-506試験トレーニング資料を試してみてください。JapanCertはあなたのIT認証試験の護衛になれて、現在インターネットで一番人気があるトレーニング資料が提供されたサイトです。Network ApplianceのNS0-506試験はあなたのキャリアのマイルストーンで、競争が激しいこの時代で、これまで以上に重要になりました。あなたは一回で気楽に試験に合格することを保証します。将来で新しいチャンスを作って、仕事が楽しげにやらせます。JapanCertの値段よりそれが創造する価値ははるかに大きいです。

購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード:http://www.japancert.com/NS0-506.html


Related Links: http://ns0-506.jpcert.com
投稿日: 2015/11/12 17:39:40  |  カテゴリー: Network Appliance  |  タグ: NS0-506Network Appliance